|
No.1
for Salt Use
Most softeners that will fit comfortably
in a kitchen cupboard have to run inefficiently to produce
sufficient softened water for the average household.
Because of its size and superior compacted softening
media (resin) the WaterBoss is not only able to provide
for any size household, but is able to run at ultimate
salt efficiency.
No.1
for Waste Water
On regeneration-which takes only
18 minutes-the WaterBoss discharges only 2.2% of its
softening capacity to drain.Some softeners discharge
nearly three times as much -
a consideration if you are on a water meter. The regenerant
water (brine) is made with softened water to avoid scaling
of valve parts. Granular, tablet or block salt can be
used.
No.1
for Flow & Features
The Association of Manufacturers
of Domestic Unvented Supply Systems Equipment (MODUSSE)
and British Water stipulate that the guide requirement
for unvented water heating systems with storage is 50
litres per minute at 1 bar pressure drop.
The unique circulation characteristics within the pressure
tank of the WaterBoss make it the only domestic softener
that meets this guide. A 1” connecting manifold
is available where appropriate.The WaterBoss has an
inbuilt sediment filter that traps debris and automatically
backwashes.
Soluble iron is removed by the ‘softening’
process- the WaterBoss will remove five times as much
as ordinary softeners.
A shut off valve is located within the salt cabinet
to prevent overfilling and overflowing.
There is a blending valve to provide a little water
hardness if preferred.
No.1
for Simplicity
No clock to set, no reserve capacity
to calculate, no commissioning necessary. Just set the
hardness with the test kit provided-you will not need
to adjust it again.
The microprocessor has an infinite memory so no correction
is necessary when there is a power failure.
The WaterBoss is set to regenerate when the metre indicates
that the capacity has been exhausted - after one hour
or one year!
No. 1 for Build Quality
The unit has been conceived and
built as a total concept to achieve the best possible
performance.
Consequently it is the largest and most robust domestic
unit available and careful consideration should be given
to its location.
Every unit goes through total system testing in the
factory.
Whilst the unit is waterproof and can be installed outside,
adequate frost protection must be provided.
There is an extensive comprehensive guarantee.
Click
here for techinical and assembly details
Click
here to visit the WaterBoss USA website
|
